2-in-One Drip Irrigation Tubing Hole Punch Fitting Insertion Tools Drip Tube Hole Punch for Easier 1/4 Inch Fitting & Emitter Insertion (Pro Punch Tool Sets)

I have had so many products for doing this chore and this one makes it very easy. Excellent!

Works like its suppose to. Easy to use and sped up the installing time for my drip system. It did take me a few tried to get a hang of using the tool to hold the tubes to put in the connectors. Save time and buy this!

The punch works as advertised on 1/2 tubing. The insertion tool only works on straight barbed plugs and cant be used for anything else such as a barbed tee. I wish there were a recess for any of the possible 1/4 fittings. No matter, with severe wrist problems, I had to figure out a way to connect 1/4 tubing onto any connector. Tubing is stiff, so the trick is heat just the very end of the tubing with a hairdryer on hot for just a few seconds and it slips right on. If you heat more than 1/4 at the end tubing it will buckle and permanently deform. Wetting the barbed connector lubes the process too.

The hole punch works well. It is a little hard to be perfectly accurate with it though unless Im doing something wrong. It is hard to see where the hole will end up. If I put a mark on the tube, it gets covered up by the plastic body of the hole punch.

I like the easy to use and the feel in my hand. I don’t like it isn’t a cutter.

Really great!

Really great!

As Ive aged I find my hand have become weaker and changing out or adding micro-irrigation has become difficult for me. This looked like a handy tool that would make it easier; however that hasnt proven to be the case. It is almost impossible to get the 1/4 tubing to stay in place on the tool in order to add another dripper to the 1 tubing. Guess Ill keep looking for something that works.

Last year I used a hand drill with 3/16 drill bit to drill holes in 1/2 hose to connect to 1/4 hose. I thought a punch hole tool was useless. I was wrong. With these two tools, the time to set up an irrigation system is much faster than before. The punch tool always does the job with one punch. It never fails. The other tool for insertion is a little difficult to use. It takes some time and strength to put1/4 hose into its groove. But I still use it as it is harder to use bare hand to do the same job.

We used this on a nationally know name brand drip line. I am fairly young and healthy and this took A LOT of force to punch through the line. My father who is a life long farmer could not get it to punch through. He said I should throw away this piece of crap.