2 inch Swivel Caster Wheels Without Brake and No Noise Wheels, Heavy Duty Casters Total Capacity 600lbs (Pack of 4)

Casters seem fine, but the Short #8 screws included are not substantial. They might be ok in hard wood like oak, but for any fir/hemlock/pine lumber, you’ll want to get some longer, maybe beefier screws. I got a lb. of #12 x 2” which is a bit of overkill, but I know they won’t be the point of any failure

Multiple sizes including all replacements I ordered came used with uniform wear/scratched indicating these are purchased in bulk used and sold to us. That’s fine for shop wheels but market it as such—don’t waste our time. Additionally this seller has blocked three previous negative review attempts.

I was concerned that the 2 size casters would be too puny to hold up and transfer an extremely heavy solid wood base with mannequin affixed. It easily weighs a few hundred pounds (approx. 200 pounds). These include a bunch of screws and washers. Two out of the 4 have the locking mechanism. It is easy to lock and unlock too. My only complaint is the rubber from the caster wheels reek. Seriously wear gloves! just from handling them a few minutes while fastening them to my base, made my fingers smell strongly of rubber and took 2 days to wash off my hands! With that said, no one can smell anything from the wheels themselves or near my mannequin now. So, only a minor inconvenience, the product itself rocks.

Exactly as described. Bought two packs to support a base I made for a cheap futon that was very low. I raised it to bed height with room for storage drawers but needed it to be mobile. This came in packs of four with two locking per pack. I used three locking for the front and three free rotating for the rear with the other locking one Un locked and the other rotating one staggered on the middle lower support bar. Super sturdy but I can easily unlock the three front ones to pull it out to drop the back. It’s in my office which I share with my new grand baby a couple of days a week and will eventually be his bed when he’s older on the days I babysit for him. For now we sit on the couch and watch cartoons!

These castors are OK but be aware the wheel is hard plastic and definitely not safe to use on wood floors with any real weight on them.

Nice axel and bearings but the wheels develop flat spots after only 8 hours, now when i move my band saw it goes thump thump thump. Total weight of my saw is 150 pounds. I do not recomend them for any weight because if they are allowed to sit on concrete floor they will eventualy develop flat spots.

We turned a wooden workbench from Harbor Freight into a pressing station for sewing/quilting. I had sliders under it, but was still very hard to move. These wheels were easy to install, and the cart moves effortlessly now. Just pre-drill a starter hole for the screws and its quick and easy. Took longer to remove all the sewing stuff and replace than it did to put the wheels on! They are sturdy, smooth and turn easily. Makes it super easy to move the table away from my design wall when I need to.

Heavy duty wheels for the size. Met my expectations

So, I used these casters for parts to make a gantry, and the bearing were perfect. They have an internal sleave surrounded by the bearing, this means that I didnt need a movable axle. The casters themselves were very sturdy and all four swiveled. So far, I have no complaints.

Comes complete with install hardware.