5Aplusreprap 12Pcs Adjustable 3D Printer Ender 3 Pro Glass Clips Clamps Compatible with Ender 3/3 Pro/V2/3S, Ender 5/Pro, CR-20 PRO, CR10/10S Pro, 3D Printer Heat Bed Clips

The only problem I have is that the black clamps sit a little high even when tighten down. I’ve noticed this with my printer so it might be different per person. But I noticed depending on the print the extruder will run into the clamp and jam it’s self. Again largely depends on what your printing.

I was absolutely sick of clips if they where not just right they would get hit by my cooling HeroMe Gen 5 On my cr10s pro the clips are screwed the the hotbed and swing over the plate taking up almost no room. I ordered these, tossed the silver ones away and used the screw based clamp. The screw for me is on the bottom of the hotbed. In doing it this way almost no clearance issues but you have to be careful not to screw it so much you damage the bed.

Works as advertised. Simple screw based clamps for bed surfaces for things like an Ender 3. If youre off into a space where the usual Ender mods arent, using Polypropylene or Garolite for a bed surface, this is one of your better choices here. It also works GOOD for Glass, etc. so you might want to contemplate this for your tempered/Borosilicate bed surface to help hold it down to the bed itself better. The only drawback is that you might have to position the clamps around the bed to compensate for physical accessibility to the screws relative to the bed adjuster knobs and the rest of your printers frame. Not a problem, per se, with the product- but this is being said so you go into this eyes-open and know theres things youll need to work out and think about using these before you go off printing with them.

These dont clear the extruder fan on the left side nor the heater block in the back so I can only clip on the right side. But recommended, get something shorter

Work great on my ender 3 v2. Recommend

The design and look is pretty cool. The durability is nice and acceptable. There is no guide on how to put this all together on the bed, but the little spacer rings go between the red adjuster and the bottom of the bed. With it all put together, I lost 2.5mm of Z height.

Low profile, keeps my glass in place

The only real issue I have with these is that I didnt need 12 and itd be cool if they could be purchased in packs of 4-6 for less money.

I use this on my Ender 3 v2 Neo with a Creality 4mm glass bed. Works perfectly and these clips hold well and stay out of the way.