5PCS A4 FEP Film for Elegoo Saturn 2, Saturn S, Saturn 8K, Anycubic M3 Premium, Mono X 6K, Photon M3, M3 Plus, Phrozen Sonic Mighty 4K LCD 3D Printers, 210x300x0.15mm Resin Vat FEP Film Replacement

Good price point and they are the right size for my printer.

Had a few sticks on the one im running currently. None really in the same spots and not every run so ive definitely seen worse. Price wise if you need to save money id say its worth it, but personally id just save up a little more and get your printers brand or current favorite fep.

Works fine in my 3D printer. Seem to be a good quality.

After my first print on the saturn 2 I messed up my FEP film. I used the plastic scraper on it because I missed that part in the instructions. It messed up in a few placed so I found this FEP here. I googled how to replace and followed it. Works great with no issues after several prints with it.

Was very happy with this film. Did the job great, held good and was satisfied with it. Price was pretty reasonable, better than most. Shipping could have been a little better, but luckily it wasnt damaged. Very satisfied with it.

My colder environment leads to prints that stick hard and FEP damage at an accelerated rate. I change FEPs a lot more frequently than most. The nice thing about these larger FEP films is if you run multiple printers theyll work for a larger Saturn and its exactly double the size of my Mars 2 so I can cut a sheet in half and get two FEPs for my smaller printer as well.

At 210 x 300 mm, these FEP sheets are way too large for my little resin printer, but theyre easy to cut in half with sharp scissors or a knife, so I end up getting 10 sheets for a pretty reasonable price. They are exceptionally clear - great for just about any resin printer. Installation is easy - just follow the instructions for your printer and be careful to get the film nice and tight. Also, make sure you remove the protective film from both sides. Thats actually the toughest part of installation for me!

This FEP film has good clarity and is large enough to work on any of the printers I currently own -- including my Halot Lite and Halot Mage, which both have larger than average bed sizes. Until you do a lot of printing, your really dont realize how quickly your FEP will wear out or get scratched, which leads to degraded print quality -- or just simply failed prints. Replacing the original, now heavily worn, FEP on my Phrozen printer with this one made a world of difference. From a value standpoint, especially for smaller printers (like my Phrozen), this 5 pack is a REALLY good value as each piece of FEP is big enough to work even when cut in half. Basically, for smaller printers this is really the equivalent of 10 pieces of FEP (old style paper cutters work well for getting a good smooth, square cut).

You should always take care to keep from damaging the FEP release film, but inevitably it’s going to get scratched up or even torn. So treat it like a consumable - keep a stock like this around and replace the film on a regular basis. Resin printing has a lot of variables - it’s always a good thing to reduce them to a minimum.

I had no issue changing out my old FEP sheet with one of these, the instructions were easy to understand and the change went very easy. I think that this multi pack is going to last me a long time, so for the price this was a great deal!