5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Voxelab Aquila, XH2.54-2P Connector (1m/39.4inch)

I started getting thermal runaway when using PETG at 235C but I was able to use PLA+ fine. Then it started giving me the error on both. I went through the troubleshooting to figure out the cause. I was puzzled because my thermistor was still saying 97k ohms at room temperature but the little bulb looked a little cracked or chipped. I got this pack and went through each one with my meter to get the one closest to 100k ohms. I think they ranged from around 93-100k. After I replaced it, I was good to go and later upgraded to a different hotend and had to change out the thermistor anyway. However, while it was in the printer it worked fine and I had no troubles with thermal runaway afterward. Be sure to do a PID tune after replacing anything on the hotend.

I used this to replace a failed thermistor on my Ender 3 and it worked with no problems, the wire for it is the right length.

Bought last October and fit great for Ender 3 pro. Kind of a process to install but not terrible. Only issue is after about 5 prints I get a low temp warning. Very frustrating when you get 50% or more into a print and then have to scrap it. Then have to repeat the process of installing another thermistor. Good thing they send you a ton of them. 1 star from me. Customer service reached out to me and are sending replacements. After going through 2 more after this review I found that it was burning the wire up next to the glass thermistor. I used high temp sealer to hold it in place and it still burned out. May upgrade my printer soon to the Ender 7.

Works great with Voxelab Aquila. My hotend temperatures were rising and falling randomly and creating thermal runaway errors. I thought buying this inexpensive upgrade might do the trick. Now my hotend temperatures are stable as can be. Look on youtube if you need installation instructions. I recommend using the existing thermister cable as a guide wire to pull the new cable through.

good, fast shipping

I have an ender 3 and was having temperature issues causing the system to shut down and make a very loud tone noise. I was having thermal runaway and it was a safety feature that shut the system down. The hotter and temperature probe was the issue and this product cured my issue.

Good replacements

Thermistors work well as expected, no product imperfections or irregularities. Shipping time was as expected, thanks.

Not compatible with the CR-10s Pro

I purchased this product when the stock thermistor started having issues. I would only be able to print for several minutes before the printer would scream out an error at me (Ender 3). Replaced this one fairly easily, but you might want to watch some YouTube videos prior to installing it yourself.