Adhesive Neoprene Rubber Mat 1/8 Inch (.125”) Thick x 12 Inch Wide x 59 Inch Long, Closed Cell Foam Sheet Roll

very little product for the price since i was going to use for insulation for hunting blind. would not purchase again

Should have gotten a bigger size.

Great product

One roll came damaged

Works just as described

The product its good quality, the glue is excellent . It smelly but it fades away gradually.

I bought this to put on outside shelf. I ordered the 1/2 inch. This was just absolutely terrible to use. After cutting it to fit it would not stick flat to the shelf. I have one roll ( it came in 2 rolls) left. It’s going in the garbage.

Worked exactly like I expected

This worked perfectly for me. I had to replace the foam that surrounds the kick plate on my 77 project car. The kick plate has a vent and door on it to allow air in. The existing foam seal that goes around the vent door had dried up long ago. So when it rains, water flows down the cowl drains, it goes inside the fender well and leaks through the kick plat because of the dried up foam. I cut the new pieces out using a utility knife. Luckily 12 inches die was exactly the width I needed. I then applied it to the kick plate the sticky part adhered to the plastic just fine. I installed it, put in the screws then put a garden hose down the cowl. No water got inside. I can now move on to restoring the floor of the car, as I could not do it until the leaks were fixed. The foam does not absorb water. I bought the 59 inch length for additional use on the car. I did not however remember to measure the length prior to my first cut so could not state if it was accurate. I got the 1/4 depth, and it was accurate as well as the width at 12 inches. I had no issue peeling the backing, nor any issue of the adhesive coming off the foam.

no comment