Audak 1 Pair Aluminum Mounting Bracket Kit Tube Clamp for 2.5 Inch Bullbar Roof Rack Roll Cage Horizontal Bar

These brackets exceeded my expectations. They are solid and well made. Worked perfectly! Highly recommended!

Used to mount an adjustable spare tire holder on an aftermarket cage on a rzr. This design seemed stronger than other styles, and so far it’s been good.

These work excellent on the Lance trailer fat ladders. I was going to make a bike rack for my ladder, but decided that would be unwise because the dynamic load on the ladder would probably do damage tot he RV mount over the long run. I did mount some other lighter items and a stud to hold the outside garbage bag.

Well made good value

very sturdy and looks decent.. will update in a few months!

Great product and well made. Installed a few more lights on my T-top and these mounts were the right choice.

First off, I think a person should know that these units are built of what feels like very sturdy material, aluminum, thick and well put together. Next, you should know that it is a complete kit. You get two brackets, you get a bunch of rubber pads that go inside the brackets, and the pads are of different thicknesses to fit different diameter tubing. So you will find the right fit for your application. Also the units come with the screws necessary to tighten them down. We are going to use them to mount our marine radio on the underside of our t-top. If, for some reason, the radio is enough weight that, with the bouncing on the waves, these mounts should turn, it could be because our rails are very smooth aluminum and even a tight grip might still allow movement. The marine environment is a challenge. But if this happens it is a simple matter to drill a hole through both mount and rail and drive a large sheet metal screw through both pieces to prevent any swivel. But that is only if necessary-it seems like the rubber pads and the ability to tighten them down quite tight should be enough.

Used them for a custom bmx bike roof mount. One grabs the roof rack tube and one grabs the peg. with a linkage between them, they are solid as could be. Even with a single finger screw to clamp.

Sturdy and stable. Rubber inserts are a little cumbersome to work with, but seem to do the job.

Very well made and solid. Used them to make a holder for a chainsaw on my side by side.