BIGTREETECH DIRECT TMC2209 V1.2/V1.3 Stepper Motor Driver Silent UART Stepsticks VS TMC2100 TMC2130 for SKR 2/ SKR V1.4 Turbo Manta M4P Manta M5P/M8P 3D Printer Motherboard (Pack of 4pcs)

Worked great! Silent drivers and stall guard make these stepper drivers the best I’ve used. Worked well with SKR1.4Turbo board. Bought two sets for a future build as well. Highly highly recommend. Box Even included a small pin layout for the driver.

Pretty darn quiet and work well. Would have preferred a version without the pins already attached, but I understand that most people want the pins on them, so there is that. Good that they include the heatsinks as the can get toasty.

Silent, with sensorless homing. Easy to install, clear instructions

Hi Quality parts, definately worth the money... and the kids love the little rubber ducks.

no problems they worked great.

swapped my a4988 drivers out for two of these and plugged them in and put a jumper between the en/gnd on my cnc shield and they worked right away! the vref came set perfect for my 1.5a steppers and they make ZERO sound!

Used these on my TronXY X5S with the Big Tree Tech SKR 1.4 board. These drivers are great. Im using them without end stop switches and that works wonderfully. These drivers and that control board made the X5S so much quieter and smoother. It was the best upgrade Ive done for that printer. Id greatly recommend these.

This stepper driver was to replace one on a functioning 3D printer. The existing one was a 8825 for the bed axis. I was getting overshoot at high speeds, and thought a larger motor with a driver that could handle more current would help. So far, I replaced the driver, but not the motor yet. I had to change a jumper setting on the board, so the steps would match my existing setup, as the 8825 used the jumpers in a different config. It works well, and made that axis of the printer much quieter. However, it actually doesnt hold as well as the 8825 did. I tried adjusting the current, but would still lose steps at high speeds, where the 8825 could still hold. I had to adjust my jerk speed down some for this driver, and it is smooth and quiet, but was hoping for more on the holding power. Maybe with a new motor, it will do better. If youre looking for a cheap upgrade to really cut down the noise, then this is for you. I wasnt concerned about noise, just looking for something that could handle more current.

I ordered UART mode to avoid having to do additional soldering, but I still received the standalone version. The soldering pads are very tiny. Hopefully my hands will be steady enough to solder them without breaking it. I understand mix ups happen, but this is annoying.

They definitely made my anycubic mega s quieter but one out of the 5 came not working. So I had to use one of the old drivers so my printer isnt as quiet as it could be. I paid for 5 but only got 4 working. The 4 that work are good though. Def makes the printer quieter.