Chip Quik REMKIT SMD/SMT Chip Removal Alloy (REMKIT)

This is a great system! I was able to remove and replace a tiny 14 pin chip. I practiced a couple of times on another circuit to learn how this system works and to adjust my techniques. Final work, using their liquid solder (diluted! See You-tube) was perfect.

Up until recently, Ive been desoldering chips the hard way. Painstakingly getting the soldering iron to temp, using a magnifying glass to see every pin or lead that needed desoldering, and doing it one by one. With this stuff? I can just apply the flux, use a bit of the low temp alloy and run the tip around to get things nice and warm, and surface mount chips just effortlessly brush away. This saves me so much time. I dont think Ill ever go without this stuff on hand again.

Worth the money!!! I was able to desolder smt components that needed to be fixed. Chipquick saved the day!!!

This stuff is magic! With a solder pump, and following the directions, almost 100% effective in desoldering. Amazing.

Ive used this in the past and it works great as always. Highly recommend. Used it to replace a Xbox One S HDMI connector.

I was impressed with results having NEVER even known such existed! Worked well the first time!

I have soldering tweezers I can use for removing a lot of surface mount components, but I have to remove my iron to use them, so if Im only removing one resistor, capacitor etc..., cant get the tweezers into a tight space, or am working with a component that cant be removed with the tweezers, this stuff is incredibly handy, However, my most common use with it so far has been removing DC-in jacks, and headphone jacks from motherboards. It makes for a super quick and easy removal for anything with multiple pins.

Easy to use and I didnt bring my board

This product works wonderfully when used according to the instructions. By lowering the melting point of the solder many types of parts are easily removed without special equipment. Then clean up the board and you can easily solder new parts back onto the board. The paste flux provided is wonderful and the board cleans up nicely after the faulty part is removed.

This stuff works well. In tough areas where you have through-hole components or SMD with many pins it will save you.