Firestik MKM2 Molded Side Mount with 18 ft. Fire-Flex Coax -W-Lugs

So far I’m giving it 5 stars. It was super easy to install. I used a step bit and light pressure to drill through my precious cherokee’s unibody. I put some heavy car wax around the mounting location to help prevent any moisture issues. The outer part has a thick rubber gasket so I’m not worried about moisture intrusion. Make sure the nylon spacer fits in the upper hole so the bolt doesn’t ground out on anything otherwise your radio won’t be able to receive or transmit anything. Use some threadlocker on the nuts and you’re done. I haven’t wired up my radio yet but I’ll be back to edit my review if the performance is anything less than 5 stars.

Bought this to go on my 2004 Jeep Wrangler TJ. I installed it under the passenger side tail light with my 5 foot Firestik antenna and Firestik spring. Works great, havent had any issues. My Cobra CB works very good with it too. I drilled two holes in the body as instructed to mount it and then I also drilled a hole in the very back of the Jeep close the the rear passenger side roll bar mount to run the wires through. I did that then ran the wires along the side of the Jeep (I dont have carpet so now way to hide them that way) and up the passenger side A-Pillar to reach my overhead mounted CB radio. Sorry the only picture I have is from far away at the moment, but I will update it eventually with more. Ran this for a couple months with no issues. I love this mount because this it almost looks factory and no wires are visible.

I bought these (2) for mounting my CB and Scanner Antennas without having to drill holes in the body of my truck. Theyre mounted on the back side of my truck bed tool box and they kept me from running a separate ground wire. Mated to the firestick purchased at the same time and hooked to the new Uniden sideband, I was able to obtain a 1 to 1 match on both channels 1 and 40. Easy to install, very clean look and Id buy them again. Thanks Amazon and Firestick!

Nothing

I purchased this to install on my 2010 Jeep wrangler. The directions are clear and the Firestik website has additional information. It was an easy install and looks like it was installed from the factory. Great mount and great company. If you use a spring between this mount and your antenna, you will need a washer or nut as the recess in the mount does not allow a proper connection. Excuse the rusty nut (it was the only thing in my toolbox that was the right fit), it will be replaced with a plated washer once I get around to swapping that out. It w

Im using this because I wanted a high-gain antenna and the body panels on my Bronco are too tight to put coax thru for a front fender mount. May have to buy another one and co-phase them. Mounting point is just behind the door.

Good, prompt service