HICTOP Ender 3 Heater Cartridge 24V 40W 1M/39.4Inch for Creality Ender 3 Ender 3 Pro Ender 5 CR-10S Pro 3D Printer Prusa Mendel （Pack of 3）

First off, the cord is long enough to reach MB case using the previously routed cable guide. Fit my STOCK hotend from my ender 3 v1. works as advertised. did not have temp gauge to check for accuracy.

All 3 ohm out good around 14.5ohms, but they are only 39 inches long. Stock heater is 56 inches so its just over a foot short of reaching when sleeved with the rest of the wiring.

Here is an item that works perfectly. Make sure your psu is 24 volt.

Seem to work very well, and cant beat the price. Heats to print temperature in under a minute with a good quality power supply, still using the first one after months on the printer but nice to to have spares handy.

works as expected.

Out of the 3 pieces ordered only 2 look usable. 3rd piece had a damaged metal core with only 1 wire, not 2 coming out of it and the 4th was just a single wire with no core. At this point I’m concerned about whether or not to even try the 2 “good” ones to see if they work. Also the length of wires is not consistent.