House Tuning 1 inch Bar Clamp-Pack 4 Roof Rack Bar Mounts Tube Clamps Horizontal Bar Clamp Mounting Bracket for Motorcycle ATV Utv Boat Trucks (1- Clamp Mount kit)

After having bought some of the 1-inch versions of these mounts, I was surprised at the sheer girth of these brackets. They use a rather thick spacer and aren’t nearly as low-profile as the others. When installing on a 1.125” bar, the included hardware is too short to easily get the bolts started, which resulted in one of the bolt holes stripping out on one of my brackets. I suppose that for the price they aren’t too bad for the price

Worked as they should

Worked on teryx4 rear roll cage 1.400 bar with 1/8 neoprene around bar. Use for the down anchors

Fits good on the roll bars

Nice and solid

Looks good!

I have these on the highway bars of my motorcycle supporting fog lights. They are the best mount you can buy for the money. Ease to mount and adjust. With the fog lights mounted in for 3 months of daily riding they have not moved at all.

I used these to mount cabelas rod holders onto a folding wagon for fishing. With the different pieces to adapt to different diameter tubing make these very helpful. Very sturdy and well made.

Good product

bought this to add lights to an ATV the length of the banner(attachment area) and description of product is to add a piece like a strap between clamps to add lights, tools etc. I used them and drilled through and slotted the clamp to put marker lights on them individually. The mounting flange pinch clamp i torqued to 43 inch lbs, and it is very solid. this is with the rubber shim stock installed to make 3/4 -19mm size. I drilled #29 wire gauge and tapped 8-32 threads and attached lights. The clamps have what appear to be stainless screws W/lock washers. This is a product i will purchase again. The top screw of the light i drilled on the edge of the clamp screw with out a total hole the bit came out the contact surface of the cap to the body and i tapped threads all the way through from the outside of the clamp to the inner diameter and only have about 1/8 inch threads and was able to tighten the screws up tight enough to not worry about light coming loose, lots of meat there.