JARDLI Aquarium CO2 Proof Tubing 16 Feet (Black)

Pros: Extremely durable, does not leak, does not tear or develop pinholes like softer tubing, can be made more flexible with heat, fitting will not leak or come apart once installed. Cons: Not very flexible, need to use a drop of oil on fittings to get this tubing onto the fittings, must be extremely careful if installing onto glass fittings as the pressure to push tubing over fitting can be enough to break the glass.

Tubing was great, very strong hold on my diffuser so good I broke it it. Very strong sturdy tubing. Can be stubborn to manipulate but with that comes security. I recommend heating before attaching. Hot water worked great.

For CO2 distribution in aquariums using diffuser units, you absolutely need CO2-rated air tubing to handle the higher pressure requirements. The standard aquarium airline tubing will only work if you are bubbling into the intake of your filter or taking another low pressure approach to CO2 injection. The reason that I cannot give this 5 stars is simple. When the CO2 is switched on, it takes around ten minutes before the diffusers start to bubble. There is no leak in the system. When turning off the CO2, it continues to bubble for around ten minutes or so because the hose has some flex. It would be nice if the CO2 started and stopped immediately, but one can compensate by adjusting the timers. One note. Be sure to put the tubing in near boiling temperate water for at least twenty seconds to soften before attempting to connect to any fittings. Also be sure to add a check valve to your system.

Good product

Fast shipping! Great price! High quality!

The prodcut isnt hard to bend, but still supple and requires a good amount of force to fit over a diffuser, making a good seal. Havent had any problems

excelente me gusta este producto

Best option for CO2 tubing. Stiffer than I would like, but works well and doesnt kink. Depending on what you are putting it on, you may need to heat it up by dipping the tip in boiling water for 5 seconds.

Installed this in my tank late august, by October it had 1,000s of pin holes in it. I was wondering by my tank was having issues, not all the gas was making it through the line, I thought it was the diffuser or my co2 checker was off, bubble counter was reading fine, tank was running on the low side. Wasted gas and money, though what bothers me more, I wasted my time with this tubing. It is stupid hard to remove my diffuser or one way valves even with boiling hot water. Wouldn’t use this for these reasons.

Exactly what I needed for my CO2 setup for my tank. Suction cups work great in and out of water.