K & S 83043 Round Aluminum Rod, 1/8 OD x 12 Long, 1 Piece, Made in The USA

Quality

The rod I thought would be good but it must’ve been flimsy as it was completely bent and it’s hard and bendy not sure if it’s supposed to be like that

Quality product.

I feel I got what I paid for, dosnt happened often.

Would like to get what I payed for. Payed for 2 only got 1

A mistake was made in that I ordered 2-83047, 3/8 Diameter rod and I was sent 1- 83047 rod and 1- 9810 rod, which is an 8mm alum tube. Thus, I could not give a higher rating. Please keep in mind that mistakes like this happen and I do understand. The part isnt worth sending back or raising a fuss about, and I am sure that it is worth the $2.00 I paid for it, so I will keep it and order more aluminum stock later. I just wanted to give a heads up in case there may be a lot of stuff like this happening with the company.

Product was as expected, but arrived bent due to poor packaging.

Then some of you might notice that the bar for the lids hinge (shown in the attached picture) can slowly migrate then fall out. I bought one of these cases for a co-worker and they were too busy to notice and push the bar back into place. Of course, they tasked me to fix it. This bar does the trick. 1/8 fits just fine though you will have to cut it to size and make sure to file down the rough edge.

I needed to make a new handle for something and this worked perfect. Soft enough to bend, yet sturdy enough to hold up to every day use.

This rod is sold as 1/4 in diameter, it actually measure .256 which is 6/1000 over 1/4 inch. I wanted to use a section of this rod to reduce the shaft size of a 1/4 in knob. The rod will not fit into the 1/4 inch knob. I can fix this by turning the rod in my lathe.