KEO 53512 Cobalt Steel Single-End Countersink, Uncoated (Bright) Finish, 82 Degree Point Angle, Round Shank, 5/16 Shank Diameter, 1/2 Body Diameter

So far it works better that any other countersinks I own, should last a long time.

It makes a dang fine smooth tapered hole. Have several fanged countersinks in the box; all exhibit steps around the edges. This one, with the sharp circular hole, is a design achievement.

This tool works great. It cut nice and clean on walnut. It is well made and looks the part. My only minor gripe is that the shavings always end up in the hole in the middle. After a few holes I have to use something to push them out.

Not bad

I’m a woodworker and needed a countersink for a 1/2” screw head and none of my standard drill-bit countersink combo but were large enough for the 1/2” head. I had a more conventional countersink only bit but it left a lot of chatter on the surface of the cut that looked terrible. This bit was the ticket in hard maple, worked quickly and very smooth and easy to control. Highly recommended.

This thing is SUCH a joy to use! Ive never used a countersink which produces such perfectly smooth, clean and precise results in wood and plastic, every time. Why didnt i buy one of these sooner?!

Great for use on wood. I first drill the pilot hole to the finished size, then use this tool to create a countersink. It cuts the wood very quickly and smoothly. It leaves no chatter marks the way traditional wood countersinks often do.

I bought this to counter sink screws in a diy closet cabinet build, and I love this thing. I was skeptical of the design at first, but this thing works better than any other countersink I own. Even in situations where I use a different countersink, I give a light pass over the hole with this one to smooth it out or remove burrs. I will never again not own one of these.

This is a de-burring tool, not a countersink. Know what your selling please. Missed return window before realizing.

I have been using the fluted countersink bits - they always left a hexagonal pattern in the countersink when I drilled them. This has been far better- perfectly round and smooth. In my few weeks of use with a cordless drill it’s been fantastic.