LiftMaster KPW5 Wireless 5 Code Commercial Keypad

We paired it with the LiftMaster 850LM receiver on our gate and it works great. Like the feature of having multiple codes and temporary codes. Looks more upscale compared to our old Multi-Code keypad.

I returned the keypad sine it doesn’t work with the gate controller that I have. The return was easy and Liftmaster does have a unit that does the job. Make sure that your controller uses security +2.0 if you want this keypad.

Easy to program and use

Exactly what we needed for the LiftMaster electronic gate we installed.

No complaints. This works with our Liftmaster gate system and is wireless, so no need to run wiring under our driveway. I used a couple of pieces of flatbar to mount it to the fence next to the gate and it looks like it was meant to be there. It has been installed and working over one year now and we still havent had to change the battery.

Tech support was very helpful

i received the unit this week, works with LM universal receiver , set up was easy , still need to install it at the gate.

We replaced an old keypad for our driveway gate with this one. The old one had buttons sticking on it after many years of use. 2 months later we are still fussing with this new one to work properly. This is the second new keypad to try. Our remotes still work fine from 400 feet away. Calls and emails to LiftMaster (Chamberlin) have not been helpful. This new unit will open the gate only half the time if a car is pulled up cost to it (like one would normally use the keypad). Product support said to change the battery which was done with a new lithium 9volt. Then they said to buy a remote antenna for the receiver. I had one that the LiftMaster dealer did not hook up when we got a new gate system a couple years ago to replace a 6 month old system that went bad (another LiftMaster story in itself). So we hooked that back up and no change. So I moved the antenna to the gate and even close to the keypad and pulled the antenna wire out of the keypad to expose that. It was only slightly better. So we moved the antenna even closer still and no change. The antenna is in line of sight and 7 feet from the keypad. I now have a sticker on the keypad to tell people to move their vehicle 3 to 4 feet away from the keypad and get out to enter the code if the gate didnt open. Thats ridiculous for a gate opener. Product support said that LED headlights affect their openers but its much worse than that. With all the problems with LiftMaster equipment and 2 of the local authorized dealers I would be very wary of their products and support.

I have 2 garage doors with 2 openers and found out the hard way this keypad can only work with ONE motor.

These made in China remotes are good until small ants decide it would be a good home. The seals protecting the motherboard are hopeless. The ants have destroyed 2 remotes in less than 15 months. Next replacement will be re-engineered with lots of silicone to properly seal the electronics. Pretty bad design.