LulzBot Mini PEI Sheet

I am not sure what was going on with my previous PEI, but I was using glue sticks consistently and get prints to stick. Since switching the stock PEI over to this one I print directly to the bed with no issue. The prints stick well, but after letting the bed and part cool I am typically easily remove the parts by hand.

Great stuff! More expensive, but the tape is already applied. Much easier and faster. Almost everything sticks to it.

Its easy to replace, and functions just as well as the factory original.

After 2 years printing on my Lulzbot Mini 3D printer, the PEI bed was showing signs of wear with lift spots. Time to replace the PEI surface! There are other PEI products available but if you check them closely you will find the adhesive is an additional item. And that process would be rather messy adhering both surfaces without air bubbles! No, the best way is to use authentic Lulzbot Mini products that have the adhesive already attached. I spent a few hours removing the old PEI sheet and cleaning the class bed to remove the remaining sticky residue. Once the glass bed was completely clean and dry I peeled back the new PEI sheet and using a plastic wide putty knife, slowly installed it being careful to remove any air bubbles. I finished by trimming off the excess around the edges. Taking my time on this project netted me a new looking machine that is back to making great 3D prints again! GREAT PRODUCT!

Arrived quickly and as described, easy to install.

Great directions. Easy to apply.

Very easy to add this new sheet to your print bed and the quality is great. It has the 3M adhesive already applied; just remove it, stick it down, and cut off the excess. Cleaning off the old adhesive is another story. I found the best way to clean it off is by applying a good amount of isopropyl alcohol and scraping it off with a utility blade. Ive done it twice now and got it down to about 20-30 minutes for the complete removal of all the adhesive to give a good surface to stick the new sheet to.

Nicely oversized to make fitting easy, made my print beef good as new

exact oem replacement from lulzbot

Once you clean your print bed, this is easy to apply. The old PEI sheet had been melted away in a couple of places because of a few bad registrations that I didnt catch in time. I had been using a film to cover those holes, but the price and relative ease of replacing the PEI sheet is much better than using a film that tears and gets caught in the print. Its so much easier to release the models, if you are using glass or a metal plate you should add this immediately