sisona 1/8 3/16 1/4 5/16 3/8 Carbide End Mills Set - Solid Carbide (Tungsten Carbide + Cobalt) - 5Pcs 4 Fulte CNC Mill Bits for Steel - TISIN Coated

I will come back and update once I have hada chance to use more of them. Maybe the material I was cutting was too hard. More use will tell.

I have been needing to elongate the slot on this bracket so figured would give these a try. I chucked one of them up and went to it. I was not slow or gentle on it ether. I only made two cuts and it loved it. No complaints from it at all and with no lube either. I wanted to see just how well it would do when rushed and did just fine. Kindof surprised for a no namer. I know that will need to run for much longer to determine its true lifespan but for the price I cannot complain. I have a budget and cannot always get the best out there and these fit the bill. Hope this helps and thanks..

Ive used thede mostly for drilling into hardened steel receivers and barrels. It works great for cutting out oin slots on round objects. When my other more expensive drill bits have failed this set has gone through the same material like it was butter. They are a little short cut so for deep holes you will need to do alot of back and forth to prevent jams and damage. Over all im happy with them.

At this point, Ive really only tested the 3/16 bit. Material removes cleanly, chips consistently. The first few cuts with this bit have been clean and crisp. The bit shows no wear, but for carbide, it really hasnt been tested hard yet. Reasonable price point, based on the anticipated bit life. As time progresses, Ill report on durability...

These carbide end mill bits are incredibly well made. They are very sharp and cut cleanly. This really is a fantastic value. I highly recommend them.

Tested the 5/8” cutter in hot rolled steel, was able to do a full width cut at 2mm depth with a feed rate of 480mm/m on my CNC converted HF mini mill. Surface finish was excellent given the rigidity (or relative absence!) and I was very pleased with the speeds I was able to achieve - quite aggressive for me but felt I should put the cutter through much more than I ordinarily would for the purposes of this review. These cutters are definitely on my must buy list. Ran it dry and did four faces on two 1/2” x 3/4” x 4” pieces. Photos show finish from roughing operation and the blue chips it produced with no sign of cutter deterioration after removing a total of 1/4” over a length of 16”!

They look very good

These are not the top of the line, but you do get what you pay for, they will do the job, but the longevity of the bits is not that of the higher quality bits

Works great

Perfect bits.