Strenco 2 Inch Hook and Loop Strips with Adhesive - 5 Yards - Heavy Duty Tape - Black Sticky Back Fastener

I was reluctant at first but I am pleased to report they are strong (both the adhesive me the Velcro). I use them with electronic devices that generate some moderate heat, so we shall see… I will return in a few months with more info if anything changes.

I bought this to put on the back of a walk-off mat that was being placed over carpet for the winter. The walk-off mat kept sliding around and so I put the hook portion of this velcro tape on the back of the mat and it worked perfectly. It held the carpet firmly in place just as I had hoped. It adhered to the rubber backing on the mat extremely well.

It works, but there are a few issues. -If you have a plastic bed liner then youll need someone to hold it up as you place this product down. -It was long enough for my tailgate, but I did have to cut off about 5 inches. This is a positive. -However; it was barely wide enough to clear the gap between the bed and the tailgate. -If I had not noticed this then it would not fit. -I was only allow to use about half of one side of the adhesive on the bed, to insure the other half reached the tailgate. -Sadly, this means there is exposed adhesive running along the entire tailgate, on the bed side. -This means dirt WILL stick to it from below and possibly weaken the adhesive. If it peels off at any time, then Ill update my review. I happen to use my trucks bedliner hide exposed wires to my self-installed backup camera. This means I had to cut slits into this to allow the wires through. No clue if this is going to cause a issue later or not. When applying this product, be sure to first lay it out so you can cut off any that extends past your tailgate. You DONT want it to extend past it. Ypu also want to position one end where youll want it to stick. Mostly to make sure both sides will reach their targets. Then partly peel off one end of either side (I suggest the bed side) and apply it. With one hand holding the peel from underneth, and the other pressing down from the top, slowly peel back the peel as you press down and adjust. This way it sticks where you want it. Then go over it with the inuded roller press. Once this is done, feel free to go ahead and peel off the other side and SLOWLY lay it in place. Use the roller to press it down to remove wrinkles and air pockets. Open and close test the the tailgate a few times, to work it into its perminate position.

If youre going to attach this to something (from its back adhesion), expect part of it to come off if you take off the strip.

This stuck very well . I also cut a piece in half and it was easy to cut and apply.

Purchased to help my mats in my garage stay put when I am dyeing yarn. Works well!

I love the gapher type tape but the hook and loop arent as strong as if like

I used this to place a micro PC behind a conference room TV. This stuck to the drywall and the PC great. Been up for over a year now, not a single issue. Since then, Ive used this for all manner of equipment placing; plug strips, USB hubs, audio equipment, and in one case even a network switch. No issues at all.

Works great for small jobs but would not recommend for jobs requiring extra strong strength. Bought this to use to replace Velcro on my pop up bed canvas on my camper and unfortunately it did not work that great. Velcro kept peeling off when I needed to do and undo Velcro to store bed. Also tried to use it to stick some lights to the exterior of the camper and the lights kept falling off, maybe too heavy for this velcro.

I’ve secured stereo speaker wire to inconspicuous areas in my installation for a clean look.