Timber Wolf Bandsaw Blade 1/2 x 93-1/2, 4 TPI

I can only say that since I have purchased it, its cut any thing I have put in front of it.

After receiving a Vermont American 31345 1/2-Inch by 4TPI by 93-1/2-Inch Stationary Fast Wood Cutting Band Saw Blade and installing it on my newly re-tired Delta band saw, I found it would not even begin to cut a block of 2 x 2 white oak, So, I read more reviews and bought this Timber Wolf blade which came with some very exacting instructions. I followed them while installing it, tuned the saw as they suggested, and introduced that same piece of white oak to it. The Timber Wolf cut it like it was butter!! What a relief and what a great blade!

The best band saw blade I have ever had or used. Tom

Great for ripping 2x6s

New bandsaw owner (used Jet 14”) and after reading online about the highest quality blades I decided to go ahead and spend the extra money on the Timber Wolf. I had alread upgraded my saw with the Rockler 10 bearing guide kit but the blade that came with the saw still wandered all over the place and took way too much pressure to cut even soft wood. It felt sharp to me but I knew it needed replacing. Well once I installed and tuned the new 1/2” Timber Wolf blade, I marked a straight square line across scrap wood and cut it using the miter gauge. It tracked the line perfectly and went through it like I was cutting air. Spend the extra cash, you won’t be disappointed. I did not give a stat on longevity as I haven’t had it very long but will come back and revise this review once I’ve put some use into it.

This blade has made a huge difference on my Delta 14” bandsaw. My unit has only 1/2hp motor which can barely run a high tensions resaw band. With this low tension design the saw is running better than ever now that it doesn’t have to fight so hard just to idle.

Wow... these blades are amazing. Ive used bosch blades for years, never expecting there ro be much difference between plain steel blades... but these are no pin steel blades. They cut very fast with much lower tension and follow a line much better than the other blades Ive used. If your thinking of trying out these blades to see if there is a difference ... dont wait. Buy them now. If you dont , when you finally get around to it, youll wonder why youve suffered with subpar blades when these are readily available. They make my Harbor Freight 14 inch saw cut like a champ.

I had a fairly new blade that would not cut, perhaps I dulled it slicing a frozen turkey. I put this blade on and all my problems with were solved. It tracks straight and it cuts with little resistance a little expensive but it works well

I have recently been using my 14 bandsaw to resaw hardwood for jewelry box building. This has required tuning the saw and building some fences to support the resawing Years ago I bought several widths of Rigid brand blades when they were marked down on clearance. After getting the saw tuned and some good fences built I managed to cut boards in half but the cut quality was so poor extensive planing was required. The reviews of Timberwolf on the Internet are all over the place but the majority are favorable so with Prime same day delivery I bought this Saturday morning and had it in hand by the late afternoon. I was aware this blade is low tension and I followed the instructions when I installed it. I made a test cut on a piece of ash and I am pleased. The quality of the cut is not perfect but it is very good and it may get better as I become more accustomed to pushing the board through without any stops. I will still run it through the planer but it will only take one light pass to clean it up. The blade runs quiet. Right now I think this is a winner, but I will also admit I ordered a 1/2 Wood Slicer blade from Highland just in case this one did not cut smoothly. I like this one well enough that had I waited until I could try it out I would not have ordered the Wood Slicer blade.

Cuts dimensional lumber like butter and handles hardwood well