Timken 6203-2RSC3 6203-2RS Deep Groove Ball Bearing 17x40x12mm

Bought for my John Deere Ride mower, 48 deck, 3 cutting blades, 2 bearings per spindle. Factory bearings did not last very long, even with regular greasing. Hour wise these have lasted 2 X as long and still going. Never know that you get what you pay for, until you have a true comparison.... Rusty

Saved me $60 over replacing the entire serpentine belt tensioner. This is the prefect solution for those off you that have a noisy pulley with an otherwise sound system.

It came in a little box the bearing was wrapped in plastic. It fit in the pulley and the pulley spins. Without the former sound effects. yay.

Received on time and in new condition as advertised. Installed in compressor motor and runs quiet, unlike the old bearing.

I cant really review the bearing but ,someone on here left a review saying it fits the 2jz serp belt pulley,it does not.. way too small. Do not buy this if youre trying to replace the pulley bearing..

Put to use right away. Needed this to repair a table saw motor.

This product was used to replace the bearings in my lawn mower. The bearings come completely sealed in plastic wrap and completely full of grease where other brands use just enough grease to cove the rollers. I would always recommend Timken to any other brand

Replaced lower drive wheel bearings on Rikon 10-325 bandsaw and they fit perfectly. No way to tell how long they will last; the original bearings froze due to sawdust contamination.

You pay a few extra dollars for this brand, but you get a quality bearing that should last. Tolerances are good too.

Order for a pool pump motor, fit perfect and run really smooth/quiet, under 20$ for 2, slot cheaper then a new pump