Yakamoz 2Pcs 1/4 Shank Top and Bottom Bearing Guide Flush Trim Pattern Router Bit Set Woodworking Cutter Tool with 10 Pcs Top Mounted Replacement Bearings

The bearing are not free spinning enough to not leave a serious wear mark on the surface of your work. If you buy this be sure to try on scrap material first. I didnt and it ruined a very expensive piece of countertop veneer that was one of a kind. I changed the bearings out with one of spare and got the same results.

I had the items for 2 days before they both bent over in half on the router table. They cut great for a minute. Would not purchase.

Did job intended really well, Delivery incredible

There have worked great

all ok

The drill doesn’t even drill through my 2mm work piece, pretty disappointed

Ive used this once to drill holes into 2 copies of super smash bros for nintendo 3ds... if you need a product that is appropriate for that very specific task, look no further. Bits were quite sharp, and it was easy to use accurately.

Hacer un arreglo casero

Pretty trash. The bits aren’t sharp enough to make a dint in 40k minis. The handle does what it should, so I just got some higher quality bits from Bunnings.

The router bit worked perfectly removing the wood. Seeing I wasnt using the bottom bearing, I tried to replace it with the bottom bearing. Next problem! I could not find the proper allen wrench to loosen the set screw. I tried SAE and metric. They were either too small or too large. Trying to figure what size it was, I tried to measure it with a dial vernier. If correctly done, I measured .080. As a side note, I wasnt applying too much pressure on the bearing. Hope this helps.