Yonico 13168 3/4-Inch Radius Round Over Edge Forming Router Bit 1/2-Inch Shank

looks good and cuts clean, good value for the money

I’ve had great results with Yonico bits, especially considering the low cost. This one is no exception. It can save a lot of time vs. hand sanding in situations where you want a subtly rounded edge.

Not bad for the money my only complaint the bit isn’t very sharp. Which I’ll sharpen on a stone. I test the bit on pine had no burn marks and the cut is clean. Fit and finish looks good. I would buy again

Great fit in the router, cuts well, at least on pine :)

Havent used it long enough to know how long it will last.

I needed this for one job and it worked great. I don’t use these much, but it worked great. No burn marks on wood or tool after using it. As little as I will use these why pay more. I ran these on about 50ft of boards looks as good as the high dollar bit would have done.

Very durable and sharp bits. I would definitely recommend and buy again.

Worked perfectly edging a mahogany bench top

This gave me a lot of tear out on poplar.

I replaced all of my deck railing caps using 2 X 6s, but I wanted nice rounded edges on the top. This was my first time using a router so I wasnt sure exactly what I was in for. I borrowed my neighbors because I dont own one. I watched a few videos first and read all of the information. First I tried his 1/2 roundover bit, but it didnt produce enough of a radius for my liking, so I purchased the 3/4. I am so pleased with the way it turned out. The edges are smooth and consistent throughout. Using a palm sander afterwards made it look even better. I did not experience any problems at all with the bit. There was a total of about 80 linear feet of 2 X 6 caps that were all being rounded over on both edges. The bit was still just as sharp at the end of the project as it was at the beginning. Couldnt ask for more.