Yonico Router Bits Slotting Cutter 1/16-Inch 1/4-Inch Shank 12101q

It’s fine, just a little bulky of a bit

great quality of this product

Made good and did the job. Very pleased

Using cutter for rail and stile dado cuts for raised panel doors

The Yonico Router Bits Slotting Cutter broke within seconds of using it. Just as other reviewers have stated, the teeth immediately broke off. This could potentially be very dangerous. I would not recommend this product.

Slotter worked fine in MDF for some t-molding. Remember to keep the speed low and not go too deep. At one point i tried to go nearly 3/4 the max cutting depth and ended up burning off a small section of the paint. Backed it off for the proper t-mold depth and had no issues the rest of the cuts. If you are cutting for more than a couple minutes at a time I would also suggest letting the slotter cool off in between sections. Im not an expert at these tools, but this is what worked well for me.

Didnt make it 3 feet down the board before the blades broke off.

worked perfectly !!

Used on plywood for trim and after about 10 of use it started smoking due to the bit deforming. It got the job done, barely. Its a throw away bit.

Poor quality