5 Inch 8 Hole Hook and Loop Sander Pad For DeWalt , Makita , Porter Cable Orbital Sander - Fits DW421/K, DW423/K & BO5010, BO5030K, BO5031K, BO5041K & 390K 382 343 Replacement Sander Pad

works perfect, easy install. thank you.

Arrives on time and Ive already installed on my sander... it works fine, will wait using it more for additional updates.

Used to have to replace these pads every couple of months when my cabinet shop was busy. Now that Im retired, my hobby work is a lot less demanding. These fit perfectly on both my DeWalt and Porter-Cable sanders. The hooks grab the sandpaper firmly and therefore fulfill their sole purpose just fine. Will buy again if I have to. Price for two is less than price for one DeWalt branded replacement.

Works well. Fit just like oem pad!

Just what I needed

did not fit Bosch 05010 as it claimed, had to add washers between sanding pad and sander to avoid screws from jamming sander and screw holes were not in exact correct place, was difficult to get installed without cross threading due to hole pattern in pad being smaller than screw pattern on sander.

Tough to install. Holes off.

It’s where weak last only for a while damaging the screws holes

Tried installing this on a Makita B05021. The center hole diameter where the metal disk fits in is a bit too small and also the three holes where the screws attach the pad to the sander are dimensionally off. Looking at the bottom I can see the holes in the pad are slightly offset from the holes in the sander. I can get two screws partially in but then the third will not thread into the sander.

this is a great sander replacement pad, easy to install, grips paper just like original.