5PCS Creality 3D Printer NTC Thermistor 100K, NTC 3950 100K ohm Thermistor Temp Sensor for Creality Ender 3/Ender 3 Pro/Ender 3 Neo/Voxelab Aquila, XH2.54-2P Connector (1m/39.4inch)

A lot of sexual innuendos.. but here it goes! I bought these for my Ender 3 pro due to thermal runaway and I probably should have tested it first but the tip of these thermistors don’t fit in the hole on my hotend. They’re too big, holes too small.. I don’t know, however I did see a lot of comments about length and it being too short, I didn’t have that issue, just doesn’t fit. Rendering my printer useless once again

Works great with Voxelab Aquila. My hotend temperatures were rising and falling randomly and creating thermal runaway errors. I thought buying this inexpensive upgrade might do the trick. Now my hotend temperatures are stable as can be. Look on youtube if you need installation instructions. I recommend using the existing thermister cable as a guide wire to pull the new cable through.

You get what you pay for, 5 normal thermistors. My old thermistor on my Voxelab Aquila X2 broke and I bought these as a replacement. As a lot of reviews say, this cable is shorter than the normal cables and that makes installation fairly annoying, I can’t bundle this thermistor cable with all the other cables because of it’s length so it looks kinda ugly sticking out lol. Other than that no issues!

Worked great on my Ender 3

Plenty of length and direct replacement. Seem to respond quickly and accurately.

Good replacements

They fit and function as described.

The quality appeared very good. I spliced the wiring rather than thread it all the way to the board. Solder joints and heat shrink. The temp fluctuates +- 4C wildly. I suspect the glass bead is a bit loose fitting. Heat paste may remedy this.

Works

This thermistor was fairly easy to replace. I wish Id done it sooner. If you see a crazy temperature or fluctuating temperature, just replace this and youll be good to go.