COMOWARE Hole Saw Kit for Wood- 16 Pieces 3/4’’-5’’ Full Set in Case with 1pcs Hex Key, 2pcs Mandrels and 1pcs Install Plate for PVC Board Plastic Plate Drilling Drywall and Soft Wood

The only negative was that the two alignment pins were angled outward instead of being vertical to the plate. I had to bend them to align with the mating saw blade. That weakened the rivet connection to the baseplate.

Will work great if you only use it for plastics or wood. Very shallow sodont cut anything to thick or you wont get through it

Decent product for the price if you are just an occasional DIY person. If you are the type that would use these on a regular basis, this kit is not for you. It took 20 seconds to cut a 4” hole in 1/4” cedar panel.

Lots of reviews about broken drill bits - This product allows you to swap bits to one of better quality. I had no problem with the bit at all, nor did I have any issues with the hole saw itself. I was cutting into drywall, so I really didnt expect any. Bottom line - This is really the equivalent to HF stuff: You get what you pay for. I needed it for one small job, and it worked just fine. If you dont set your expectations too high, you wont be disappointed.

Unassembled with no instructions.

I had to install a/c split duck and needed 3.25 hole saw. This set was a tad more expensive than name brands but you got so many more sizes than just one for premium brands. It barely did the job and took very long. The inside of the case smelled very bad and was oily. I probably will not have to use again. If using for only 1 job get the better brand with correct size and dont bother with this. For many jobs and sizes, do not get this brand. For occasional use, this brand might work for you.

These saws are useless for cutting wood. I used the hole saw to cut a 2.5 hole in the side of a sink cabinet to run hoses while replacing an undercounter dishwasher. That first hole was fine. When I went to cut a second hole through the floor of the sink cabinet I learned that the saw teeth had been worn down to nubs while drilling the first hole. The saw was no longer usable. Probably these saws could be used more than once for drilling holes in styrofoam or wallboard, but they are useless for drilling holes in wood. I did get the dishwasher installed successfully using other means to cut the second hole in the floor of the cabinet.

I needed a hole saw to make corn hole tables and this one was very inexpensive than most. It was a little difficult to put together, but it worked.

The bit for the hole saw broke after about 5-6 uses. Its cheap so I didnt expect much, but still, the bits are so brittle that they should give you two. Especially since they dont use a standard sized bit.

i bought the set to make holes in 3/8 plywood for my greenhouse .about 400 holes cut with the 3 inch bit and its still quite serviceable. great value for the price , am very pleased.