FivePears Up&Down Cut Compression Spiral Router Bit for CNC, 1/8 inch Cutting Diameter and 3/4 inch Cutting Length 1/4 in Shank Carbide End Mill Router Bit for Wood Carving Engraving Grinding Grooving

Normally after 10-20 sheets of parts, most bits have chipped tips. This bit has gone 92 sheets so far and still looks great. This after cutting about 20 parts per sheet in 3/4 ACX.

This is well made, every bit as good as the more expensive Freud and Rockler bits I own. It comes in its own plastic case that closely matches the size of the bit for easy storage. It may seem trivial, but I store my bits in their original packaging, and the cases on Freud bits huge, so much bigger than the bit they hold, this case is perfect for how I like to store my bits. I haven’t used it enough to speak on its long term durability yet, but there are no red flags yet as far as the cut quality or craftsmanship is concerned. Recommended.

Personally, I believe they are way better than the ones that cost twice the price!!!

Downcut bit broke within the first 5 seconds of use. Up cut bit has faired a little bit better

I wanted to make slotted holes in oak. These pieces were an inch thick and for holding a table top on. The bit cut clean, fast and held up for multiple holes. Ill be buying more from this company.

I liked how clean it cuts. I ise this on a cnc for cutting out letters and pockets in wood.

Nice as most better I dont know price was right Shipping was on time its my back up used it twice like it in plywood down cut

Used with dewalt dwp611 router.... only way it cut was if depth was 1/8, and even that burnt the wood... had to go VERY slow. My cheap yonko bit performed 1000% better than this on same material (particleboard with 1/16 veneer top)... tried different speeds of router - all same result. would return if it didnt look like picture after 5 cuts.

I got the 1/16 bits to try routing some freehand designs (no CNC) and they have worked beyond my expectations. Given the small bit size, I anticipated that they would have a relatively short working life. Ive used these bits on around 15 (each) projects for designs ranging from a few inches to a couple feet on a variety of materials (mostly red oak) and they still cut just as well as they did on day one with very little maintenance. I clean the bits after each use but they have needed no sharpening. I can only imagine how much better they would be in a CNC. Highly recommended.

Ordered three bits and had them delivered today. The solo compression arrived flawless. The two pack of 1/16th bits came with one bit having the top busted off. Not sure how to contact the seller, but if I can get resolution I will update this review