Minoston Z-Wave Plus Smart Plug, Outdoor On/Off Outlet Switch, ZWave Hub Required, Weather-Resistant, Built-in Repeater, Work with SmartThings, Wink, Alexa, Black(MP22Z)

Very well made. Using it to control shop vac attached to my table saw. Instant on-off.

The plug is not 45 degrees offset... its just a straight old plug, which means the cord does not hug the wall but rather sticks rather far out from it. On top of that, joining to a Z-Wave network using Hubitat, this item is recognized as a Zooz double outlet. After research in the Hubitat user community forums, found how to connect this properly (its quite a workaround), but it shouldnt be that difficult.

Used and integrated to my existing Z-Wave mesh, (SmartThings) + mostly GE outlet/switches and it was seamless. Currently working for my gazebo and so far no issues. Follow the instructions (READ FIRST) and there should be no problems.

It was easy to add this to my z-wave hub. Put my hub into add mode, press the button and it showed up. Its responsive and have been working well with the heavy rain that weve had.

I got this to replace a failed GE plug that I was using in the backyard. I found that connectivity was intermittent and needed to relocate it/switch it with another outdoor plug I had. Bottom line is, it works fairly well, but it needs to be closer to your home for it to work reliably, whereas I have found others (like the GE plugs) that seemed to have a better range.

I am using this smart plug to control my patio lights through Amazon Alexa. Very easy to connect to my SmartThings Hub using the SmartThings App on my phone and pressing the button on the smart plug 3 times. Alexa discovered the new device immediately. It is about 30 feet from the hub and about 15 feet from another Z-wave switch. Like the flat angled plug as it does not block the other outlet where it is plugged in. Easy setup, weatherproof, good value, and works as expected.

I have this plugged into the outlet at the side of my garage to control the landscape lighting. I got it configured with Smartthings easily enough but every week or so it has gone offline to where I cant control it in the app and so I have to go out and try to re-add it again. Hopefully these are initial teething problems that stop occurring.

Perfect Z wave integration with Smarthings, dimmable, do not use with appliances only dimmable lights

Product connected to Vera Edge but get “Failed at: Setting Special Association”. Switch will still turn on and off but app thinks there are failed devices. Cannot find anything on Vera’s help about what a special association is. Resolve the special association error by changing Automatically configure to “No”

I purchased this outlet to give me the ability to control a submersible pump I placed in the pool for emergencies when Im out of town. I set the pump up with zWaveJS on Home Assistant with the other 40+ devices on m zwave network. It seemed to operate fine during the day or two I tested it. The pump was setup with an automation to turn it off after it ran for 15 minutes. I left the pump in over a weekend and when I came home I found that it had somehow turned itself on and drained thousands of gallons of water out of my pool. I fortunately got home before it could have caused catastrophic damage. There is absolutely no log in zwaveJS or Home Assistant of the pump turning on or running while I was out of town. Someone this thing turned itself on. DO NOT BUY THIS