RG58A/U COAX CABLE 3 foot Jumper for CB / Ham Radio - Workman CX-3-PL-PL -Made in the USA

I use these in my mobile ham radio emergency go kit. Works as advertised and does not introduce static or interference during broadcast or receive.

I used it to connect a meter.

Perfect for my CB radio antenna tuning. Thank you. Jack

workmanship and ease of use

Its ok

It is an important part of the test gear of my transceiver, if it fails my P.A. will be damaged.

I’ve been using these jumper cables for a while and the work well!

I have no problems with these cables as jumpers except on 2 radios. When the ring is fully tightened, the connector is still loose.

It isn’t hard to make a good coax cable. This product is a fail. I doubt the one I received was actually a Workman product. The molded plastic on each end looked diseased. The plastic didn’t completely fill the mold and had the appearance of being eroded. The plastic was still slick with mold release agent. I’m confident this was a product from a beginner level sweat shop. Connected between my set meter and radio: no signal. Used a spare 18’ cable to isolated the problem. Problem was gone when this cable was eliminated from the circuit. Spend the extra money on a better cable, or just make your own. If you still feel compelled to buy this one, try the following: obtain the cash equivalent of the price. Throw it into either a fire or a garbage disposal. Proceed to buy a better product. The result will be the same (should you have the same experience as me).

Good for connecting radios to meters.