TEMO Carbide Downcut Inlay Router Bit 1/32 Inch Diameter

I used the 1/16 downcut bits to cut mahogany and maple. The attached pictures show the mahogany, all of which was cut with the 1/16 bit. The maple was largely cut with a 1/8 bit from a different maker, but the small holes in its center were cut with this 1/16 bit. I couldnt be happier with the results. No tearout or chipping at all. I ran the bit at 18,000 RPM and 36 IPM.

Great bit, work perfect for my fine detail project on my CNC router, used slow feed and speed with perfect down-cut quality.

Arrived the day after I ordered. The set of bits is exactly what I needed.

using these bit for guitar inlay work.

Got these to do some detail work on my 3018 Prover and they do seem to work as expected. I have used the 1/8, 1/16 and 1/32 so far and they all cut smoothly. Note I am being extremely conservative on cutting depth and feed rates as Im not ready to test the limits of these, especially the smaller ones. I program to cut the main areas with the larger bits then come back and do increasingly tighter profiles with the smaller bits and it seems to work well. Am cutting on red oak right now and they cut smooth and clean.

TEMO is our go-to when we need to purchase more CNC bits. They last a long time (as long as you dont screw up and break them, user error!) They are delivered quick. I purchase their 1/8, 1/16 and 1/32.

This is my favorite bit. I use it on my CNC to cut small stuff with a great amount of detail with minimal sanding. These don’t break unless I do something dumb, like dropping them or forgetting to switch the router on...

I purchased two of these bits and both of them broke just after a couple of uses.

Cuts efficiently, and cleanly. Minimal heat generation. Sharp and precise. Update 10/17/2020 This is the second one broken, although cutting speeds and feed rates were well within range. Not sure about the product anymore.

Working as expected