TRUE COMPOSITES Carbon Fiber Sheet & Epoxy Resin Kit (36 x 6 + 8oz of Epoxy) 2x2 Twill, 3K, 5.7 oz. - Carbon Fiber Fabric, Carbon Fiber Repair Kit, Kit de Lámina de Fibra de Carbono y Resina Epoxi

This product is impossible to work with. I used professional super sharp hair cutting scissors to cut small sheets of carbon fiber and they all just fall apart and shred into strips while working with it. Useless!!

My first order was forgotten, either way the second one was fulfilled quickly. The resin is no good. I ended up using gorilla glue epoxy instead and it works better. Good carbon though

it is very good product

Tried twice. Mixed one capful of each wouldn’t set up. Tried a digital scale in case that wasn’t precise enough. Still didn’t work. Inside 70° low humidity. Followed directions. Mixed for 5 minutes before applying.

I used this product parts 50/50 and its still not hard just like a sticky mess. I putting this on a carbon hood and I think it just ruined the thing. I was fixing a small crack now its done for. Dont buy this product. Not even labeled.

Im using this kit for my first attempt at carbon fiber. With that in mind, my project went into the trash but it was not the fault of the kit. The epoxy resin worked great and the material was fine.

Ordered this kit and received it without the carbon fiber. Had it replaced and there was no carbon fiber on the replacement. Now I have an errand instead of a carbon fiber part. Find a competent company to give your money to.

This is not real carbon fiber. This black tarp material. Does not adhere very well nor does it qualify for finished looks. Money wasted.

I used this product to repair a cracked top tube on my carbon fiber bike. I found, and followed, some videos I found on YouTube on repairing a bike using carbon fiber. I would highly recommend buying some heat shrink wrap to use on the carbon mesh after youve applied it. If youve worked with fiberglass before youll find that carbon fiber is nearly identical. I used small pieces and took my time in placement of them. I didnt wear gloves and didnt get any of the resin on my fingers. If you let the resin get sticky before you attempt to lay the fiber weave youll find that it sticks quite well and stays where you put it (I laid down 3 pieces). After the carbon was laid in place and resin applied, I wrapped the area with plastic, then with duct tape, and, finally, heat shrink wrap. After heat shrinking with a heat gun, I let the material dry for around 30 hours. It set up perfectly and required minimal sanding. I was very pleased with the outcome!

It was delivered on time and what I received as was indicated. The product is weak, carbon fiber is low grade and the resin-hardener. Carbon is very airy, the epoxy at 2 to 1 mix did not form at 70 control degrees for 48 hrs, leaving the project a flimsy useless.