Xenocam 12 Pack 2.1mm x 5.5mm Male CCTV Camera DC Power Adapter Connector

This product is used to provide terminals for DC power connections. Its usually used in CCTV camera work. Im using them to provide power for active metering.

Works great just as described.

Install my 1st One today!! Worked great and looks awesome

These worked for me.

These and a 9 volt battery

I had to build a fan power cable with 8 drops, and these things worked great.

Absolutely satisfied. Have one exposed to outdoor climate a few months now, works amazing. I wish American companies still made stuff this good. Good job guys.

The connectors looked like a great idea with the screw down wire terminals which would allow a bigger gauge wire to be used with the 2.1 x 5.5 mm plug. Unfortunately the quality of the clamp and the plug is not very good. I connected using 18 gauge copper zip cord and the screw terminals would not consistently grab the bare wire tightly enough to hold as well as a soldered joint. When tightened down as much as reasonable for the screw size the wire could still be pulled out of one or both terminals. Part of this is due to the design, the clamping surface is very small and smooth and the short design of the plug places the strain too close to the clamp. If a person plans to use these for a purpose where there is zero pull or movement and then covers wire and connector with a continuous piece of heat shrink tubing they may work OK. If you anticipate any pull or movement of the wire it would be best to solder the wire in as well or rather use a solder-type plug with built in strain relief device. Im going back to using the soldered type fitting.

Good

These are really handy. I am a DIYer/tweaker and I got these to make my own custom DC cables. I use a fairly thick star quad cable and finding solder barrel jack are almost impossible that will handle this thick gauge of wire. These screw terminals handle that gauge with ease and tighten down tight enough that I am not worried about the wire falling out. With these I can make a DC cable in under 15 minutes. Finish with a bit of shrink tubing and the cable looks really good. Excellent product!!