CURT 55370 Vehicle-Side Custom 4-Pin Trailer Wiring Harness, Fits Select Subaru Forester, Legacy, Outback, Tribeca, B9, Impreza WRX Wagon , Black

Beats having to use t-taps after identifying the correct factory wire colors, then having random aftermarket wires strewn about. This solution is both easier, and more importantly, much cleaner and more professional. Took all of fifteen minutes in my wifes forester from start to finish. Until I pull the harness from the spare tire well, you cant even tell it exists.

I was dreading adding the wiring to my 1996 Subaru after having the trailer hitch installed... but fount that Subaru had made the connection easy to find and nothing more than a snap in connection. Perfect results.

Easy to install

The directions that came with were a little vague, but with the help of a YouTube video, this was a ten minute installation job in our Outback wagon. The harness stays out of sight under the spare tire cover till needed. I wish the installation of the hitch itself had been this simple.

Love it. Easy install, it plugged right into the Tribeca B9s lighting pigtail in the back. No cutting or splicing normally needed. I opted to put the trailer side plug wiring through an existing poke through plug so i did have to cut the trailer end plug off to feed the wire through. You dont have to do that, you just leave it all attached and store it in the little inside compartment in the back of the Tribeca B9.

The instructions said where on my 2002 Forester to find the mating plug--I had no idea a plug was even down there, but it mated right up and works the trailer lights just fine. Excellent product.

Installation is very easy. Adequate cord length.

Custom fit for my subaru, plug and play

Solid product, for matching subaru models installatuon was a breeze. Found the connecting harness on the right hand side underneath the trim after taking out the big foam block on that side of the spare tire. Connect the plug and find a location for the Curt Harness, with the provided 2 stick tape I found a nice location tucked away in the right quarter panel of the vehicle. Run a length out and thats it. Done and done 15-20 minute job.