EPAX nFEP Film Sheet 200 x 140mm Thickness 0.125mm for E6/X1 and Other 5.5/6 inch UV Resin 3D Printers, Pack of 3 Films

Really helps in printing do the resin doesnt strict to film easy clean up

This stuff works so much better than the regular fep sheets. Since having installed this I have not have a failed print due to it sticking to the fep, my fails are completely my fault now. Lol.

First of all, this is a great product- Im not sure exactly WHAT it is, but its not FEP... Whatever it is, though- it works. And, works well. I have replaced the original FEP sheets in the machines I use for production with these. I DO have an EPAX X1 Printer, which I also really love, and of course I use the Non-FEP sheets in that. But, Its going in EVERY printer once I have a chance to do so. What makes it better?? Its hard to be objective in a review of a product like this, because there is no really easy way to measure what makes it better since there are so many variables in SLA printing. But, I have far fewer failures with this film caused by prints sticking to the FEP. It also seems to last longer between replacements. Now, the company. You cant ask for better customer service- They are prompt at replying to inquiries, knowledgable about their product, and willing to help customers. They are also very proactive when it comes to customer satisfaction- The last set of FEP sheets that I ordered had a mistake in it, they shipped only one sheet rather than three. I didnt catch the mistake- as I had just put them on a shelf to use later- but I got a letter from them, along with the missing sheets, explaining that they had made an error, and were correcting it! Thats what I call service.

After losing a few prints to resin sticking to the fep I switched to the Epax nonfep. This stuff works as advertised. I havent had a single failure due to the resin sticking since switching. It is also easier to install, it is more flexible than the standard fep. The fact that prints dont stick to it should increase its useful life also. Great product.

Seriously this just makes your printer better, since it doesnt stick to the fep, supports break less often meaning less failed prints.

Product works amazingly well and it is hands down the best fep I have used. My only complaint is that the sheets are filthy when taken out of the package. Covered in tons of specks and some sort of adhesive dingle berries. I was able to gently clean them with microfiber rag and some water without damaging the fep or I should say nfep. I recommend trying these sheets if you are having fep sticking issues.

I tried this out on my Elegoo Mars and so far its ok. Im not wowed or astonished. It does the job. But I think Im still replacing it at about the same rate I was replacing regular FEP. Maybe my printers not high def enough or etc to show a difference, but with an Elegoo Mars, using Elegoo ABS-Like resin, so far its all the same.

Used on a Voxelab proxima 6 4k. Releases perfectly. I dont hear the usual drum sound when the bed pulls away from the nfep. Was a bit of a pain to punch holes in it but I had a punch to accommodate the two sizes of holes. Seems worth the cost and trouble.

Works great, nothing sticks to it, seems a little tougher then standard fep sheets.

Well I have always been skeptical of the rebranding of this film as “nfep”. So recently I did a few upgrades (Kapton Tape, fresh grease) and decided to swap the very cheap FEP with the more expensive nFEP. Well 10 plates later and everything is printing… not a single fail. I usually get 90% or better but this is noticeable. Call it what you want , it’s working and that’s what matters !