EPAX nFEP Film Sheet 200 x 140mm Thickness 0.125mm for E6/X1 and Other 5.5/6 inch UV Resin 3D Printers, Pack of 3 Films

After losing a few prints to resin sticking to the fep I switched to the Epax nonfep. This stuff works as advertised. I havent had a single failure due to the resin sticking since switching. It is also easier to install, it is more flexible than the standard fep. The fact that prints dont stick to it should increase its useful life also. Great product.

These fep sheets work better that the spare that my epax x1 came with. These ones I have had no problems with my prints sticking to the fep sheet and for the price their perfect.

I have much more success with Nfep then fep on all my lcd machines!

Using this for almost a year and its works great!

I tried this out on my Elegoo Mars and so far its ok. Im not wowed or astonished. It does the job. But I think Im still replacing it at about the same rate I was replacing regular FEP. Maybe my printers not high def enough or etc to show a difference, but with an Elegoo Mars, using Elegoo ABS-Like resin, so far its all the same.

A must, get it.

Never again using regular fep sheets… these are excellent

I have had nothing but headaches from this product. I was getting respectable success before trying this stuff. A weeks worth of failed prints trying to get this nfep to work. I tried calibrating every variable I could, heated my enclosure, re leveled the bed with different paper thicknesses, slower lift speed, longer exposures. A failed print from this film broke one of my lcds. This film seems to make light pollution worse, and seems to make an even worse popping sound from the normal elagoo brand fep. I have two longer orange 30s, if any printing wizards out there have any advice for me I would really like to get some of the results other people are talking about. But so far this stuff has set me back.

The film arrives flat which is nice. All three are in one cushioned envelope. I think I would have preferred to have some protection between them but you can slide them all out and peel one off. For the price, its hard to complain. I like have 3 spares ready to go.

Im new to 3d printing and of course my first 3 prints failed. I installed one of these nFEP sheets and have not had a failure since! Excellent product!