Oreck XL Vacuums Best Roller (1 Brush & 3 Belts)

We recently had to replace the belt on our Orek and saw the beater bar was pretty old. Ordered the parts and had it up and running in 15 min. Super easy to do!

This vacuum is 20 years old....still works.....sorry China American made

Home use

30+ years Oreck still going strong, new roller brush and belt works just fine! I have no idea where the 9x2x2 measurement comes from but dont take any notice. It really is 11 1/8 inches from bearing plate to the edge of the drive pulley.

Used to replace worn out part.

From a mans perspective! Its the holiday season and I have picked up some of the slack around the house by doing some dusting and vacuuming after all the Christmas decorations are put out. I could not believe how HARD it was to vacuum, it was a real workout. No kidding, i was sweating pushing the Oreck vacuum. I asked my wife about what was wrong and she said, Nothing is wrong, it just pushes hard! There is no way it should be that hard to push a vacuum. After a very little research I found that replacing the roller was all that was needed. This roller took less than 5 minutes to install, just look at the old roller before removing it and the orientation will be obvious. After installation, NEW SWEEPER! Glides over the carpet like it should. And here is the interesting thing, the old roller had brushes that look really good. So if your Oreck pushes hard, replace this roller.

Purchased to replace the roller on a U4190H2PDCOST. For perfectly, belts nice and snug.

Not at all easy to install. Needes TORX head bits and the factory REALLY tightens them in place. TORX head screws are quite deep and most bits will not be long enough to reach the screws in that size.

Works exactly as advertised - thanks!

Perfect fit and easy to install!