Retroflag NESPi Case+ Plus Functional Power Button with Safe Shutdown & Cooling Fan & Heatsinks & Flannel Bag for RetroPie Raspberry Pi 3/2 Model B & Raspberry Pi 3B+ (NESPI Case+)

Great box for my Retopie! Remember to get the soft shutdown scripts!

-easy to put together -Pi stays cool under load -dude it looks like a mini NES! -Installing the scripts for the switches is easy and works great Highly recommend this for your RetroPie setup or if you just use your Pi for internet browsing and want a cool case.

A great shell and works great. I love that the power and reset button both work and that the red light works. But the instructions on how to wire it were iffy at best. I had to rewire the fan.

I absolutely love this little thing. Really high quality build; comes with everything you need to assemble. My only complaint is that the screws with the fan are a little too long, and they left marks on the top of the case when tightened completely; be cautious not to over tighten fan screws! Highly recommend this product!

I love this case. Ive had it for a while now. I really like the SD Card storage in the bottom of the case. My only thing that bother me about this case is the fact that if you dont put the sad card in your Pi just right, it will most certainly fall into the case and you will have to take the whole thing apart to get it out. Ive done that about 3 times now. Ive even tightend the screws down as far as I can go without stripping them. I’m just more careful about how I put my cards in now.

This case is great. It looks great, functions perfectly, and is easy to put together. I couldnt imagine using a standard case after buying this. The fact that it comes with a fan is an awesome addition too.

This made what was going to be a nice gift of a retrogaming system into a great one. The extra board and downloaded software made it super easy to shutdown the Pi before cutting power. The heat sinks and fans made sure to let the Pi run at higher speeds. And the retro look was just the cherry on top. Came with the only screwdriver I needed to assemble it. My only quibbles: Directions didnt tell me where to put the flat RAM heatsink (turns out, the bottom). And I used an exacto knife to open the exhaust port a bit, those holes are pretty small/thin.

This was really easy to put together and setup, and I would 100% buy one again. It would have been nice if they provided a guide to setup the safe-shutdown feature, but there were some great guides online that made it pretty easy to setup.

Materials could be a touch more robust but went together well. Once done it performed well.

Everything fit together nicely and the build quality is pretty decent. The shutdown scripts work as advertised as well, which is an AWESOME feature. My only complaint is that the fan doesnt seem to move air or cool the case whatsoever. Other than that, its a fun little project.