Sackorange 608 ZZ Skateboard Bearings, Double Shielded,8x22x7 Miniature Ball Bearings（Pack of 20)

works in a lot of prints for 3d printers. i used to add to prints for a mount for the filament spools and a filament feed guide. greatly reduces tugging and grabbing and i have plenty of extras!

Got these for 3d print use, some are definitely smoother than others but for what i needed them for, perfectly fine. If using for a skateboard etc, might wanna seek something of better quality unless money is super tight

I had several damaged bearings that could hardly turn and one where the shielding came off completely. Minor issues are the outer diameter is small by about 0.5mm and they wobble quite a bit. I use these for little 3D printer project but I doubt I would ever put these on a skateboard.

Used these in a small lawn windmill. Only needed 2 but have plenty of spares.

The dimensions are WAY off. Pressing these in was more like dropping a toothpick into a volcano. Luckily i dont need a press fit for my application, so it didnt matter. You really get what you pay for here. Also the race was PACKED with FOD. So much aluminum or steel glitter is packed in with the bearings, it feels like sand when you move the bearing around. Only two out of the pack where smooth. This is real bottom of the barrel stuff, but its also literally the cheapest i could find. Im pretty sure the oil that was covering them was some kind of caustic nonsense and it made my skin red where it touched me.

I am not using them as they are intended to be used. I am over speeding the bearings. But they are holding up

good price, bad quality,

These bearings worked for what I needed them for (filament spool rollers). They were sticky at first but as other reviewers pointed out that was easy to fix. What cant be fixed is the variability of the tolerances. The diameter of the inner hole was inconsistent even on opposite sides of the same bearing. A few of them also came with the metal shields smashed. They can be removed pretty easily bit if you need them to be shielded I would look elsewhere.

No tienen la medida correcta

They work. Theyre decent quality but from what I could tell, not for high precision applications. The center bore wasnt always exactly centered and several spun rough but did work and will be sufficient for my needs. Id guess these were pulled from old equipment as many of the ones I received showed signs of previous external wear. I also had to clean these up as they were sticky to the touch, smelled awful and were initially very difficult to spin.I soaked half in Mineral Spirits and the other half in Acetone. Both methods seemed to clean these up really well and they all spun freely after cleaning. Ill likely repack with better grease when Im ready to use these. For my project, im more interested in lowest possible resistance and not concerned with speed or