Vacuum Bare Surface Canister Floor Brush, Compatible with Kenmore

Perfect replacement for my 20 year old Sears Canister Vac Floor brush. I was pleasantly surprised that I could find an exact replacement for the old floor brush. Noticed that there are 2 holes now ( I read that others had a problem with the attachment hole being in the wrong place) So for those concerned about it - problem solved! It fits my old vacuum perfectly and is the same size and same quality as my original floor brush. Very impressed and very pleased!

Seems to fit great! My Kenmore is an old model 116 25512506. Brush attachment on Kenmores webs site to fit this model was part #4370358, which cost roughly $40........This piece was about $10, so I thought I would try it......When you flash on this product, it allows you to input a model # to see if this brush is compatible......for my model it said it could not determine whether this part was compatible. Well, it arrived and seems compatible in every way. Same size, even fits in attachments case on back of vacuum cleaner. This attachment has two holes in it, I guess to allow it to work with more models. Seems to fit exactly the same as the old one. Have not tried it yet to see if works OK, but I see no reason why it shouldnt work fine.

Great product!!

I have been using these for 20 years, buying new ones as the bristles on the old ones wear out. I use them in the house and in the garage. On this latest purchase, the holes in the handle socket are in the wrong position, which doesnt really matter much because my pipe can also be a friction fit, but the friction fit is a little on the loose side as well compared to earlier versions, but still functional. I just dont know how a product that has been around for so long can get screwed up by the manufacturer. Anyway, my solution was to remove the bristles from the new unit and use them to replace the bristles in the old head. Heres how: take a wide, flat blade screwdriver and put it in the end of a long edge near a corner. Pry the plastic back from over the corner to get one corner free, then repeat on the adjacent short edge. Once two corners are free, the bristles will lift out and you can put them into your old head using the same procedure. If you are having difficulty, soak the whole thing in a bucket of hot water for a few minutes to soften the plastic.

Just didn’t fit my vacuum

This attachment works better on wood floors than the one that comes with the vacuum. Thank goodness I was smart enough to buy this when I bought the vacuum because I immediately took the other one off and started using this one.

It works great-do the job!

exact size as original. fits right in tool storage area of vacuum

ok

Good replacement. This brush doesnt have wheels, but as I found out after use, its not necessary. Yeah you have to guide it a bit, but it is slick and does a good wide vacuum. The brushes are slick and the inlet is wider in all respects compared to the original. The tube fits perfect and the holes are aligned properly and large enough. I recommend this brush