KILMAT 50 mil 50 sqft Car Sound Deadening Mat, Butyl Automotive Sound Deadener, Audio Noise Insulation and dampening

Ive installed in my 87 s10 blazer, made a huge difference from what It had before. Took the vibrations out and did quite down a bit. Which is why i also installed in my 82 c10, I installed with a closed cell foam and i feel this combination worked the best . for a truck with a blown 383 3inch straight thru turn down exhaust set up , it made a big difference. Just recently did half my new silverado , definitely a must if youre doing any audio. Plan on installing closed cell foam also. Also sticks well so far, after you roll it I dont expect it to come back off easily.

Used one kit to completely cover the floor of a Sierra extended cab truck. Covered floor and up back of cab. Still had about 4-6 sheets left over. Throughly cleaned the metal and this stuff stuck right on. Doing it in the sunlight let’s you contour the sheets to fit exactly how you need. Overall pretty good noise reduction. My truck is a duramax with 5in straight pipe and axle dump and the drone is significantly less than before.

I used this on the floor of my car. Put a double layer down. Definitely muffled road noise but did not eliminate. I plan on buying a second box to do the doors and even the trunk. Im certain that will help even more but I dont think it will cancel all road noise.

Works amazing just some places needed too be doubled up

The hardest part of the whole install was removing the headliner.

Very impressed with the performance of this mat, especially for the price. I installed it on the floor and rear of the cab on a 2006 F350 6.0 Powerstroke. I still havent finished the job but Ive heard enough to rate the product. I plan on doing the doors and ceiling tomorrow. I started the truck just now. This is without the factory carpet and pad installed. Without the boot on the floor shifter. Without the seat installed. The cab noise has been significantly reduced. Night and day difference. This is the most affordable mat I could find and absolutely will be buying more for two other vehicle projects I have.

Installed in a 2021 Dodge Challenger and has helped with rattles and hollow sounds from all locations in the car. Easy to install. Make sure you measure several times and cut once. Save all your scraps they will come in handy for those hard to reach locations.

I put this on my 78 F150 to reduce noise in the passenger compartment. I installed in the doors and on the floorboards. It is easy to install, high quality, and a fraction of the price compared to the big names in the industry. My doors now sound like a high end vehicle when they close and cabin noise has reduced significantly. Dont waste your money on the more expensive brands. This is just as good for a more reasonable price.

This stuff is legit. Just as good as the big box names and a fraction of the cost. Goes on easy. Smoothes put nicely and quick. Very easy to work with does what it says it does. One box goes a long way while doing a jeep wrangler. Only used about a quarter of the box so far and have gotten the rear cargo area floor done and the passenger front floor pan. Highly recommended. Just be sure to get the three size install rollers and it will make your life easier.

It is easy to handle, easy to cut, easy to apply just over all easy. The hardest part is probably the assembly and reassembly of your vehicle. I used this for my 2022 Nissan Altima.